50kg Payload Simple Mechanical Vibration Test Machine for Laboratory and Production Line
Product Introduction
There are two main test functions for LABTONE Mechanical Vibration Test System : fixed frequency test and frequency sweep test. These two testing functions provide users to test their products with: vibration function test, durability test, packing and shipping test, resonance search, resonance reside, stress screening, fatigue test...And so on.
The Fixed Frequency Test Mode : set a test frequency point and test time, the vibration test machine is tested according to the set conditions until the end of the test time, the operation mode is as (Figure a).
The Frequency Sweep Test: set the starting frequency, termination frequency and sweep time, vibration test machine is tested according to the starting frequency gradually increase or decrease the vibration frequency to the termination frequency, and sweep speed determined by the sweep time, the operation mode is as (Figure b).
Economy mechanical vibration test machine Application
Customer Services
Presales:
- Technical consultation: test method, laboratory planning and suggestion.
- Equipment selection: selection scheme, FAQ.
- Product testing scheme.
In-Sales:
- Customer communication and progress report.
- Guidance for pre-installation preparation, equipment commissioning and test run.
- Calibration (when Third Party’s verification is required).
After-Sales:
- Technical training: operation of equipment, daily maintenance, common fault diagnosis and troubleshooting.
- Scheduled on-site service: Detection of problem as soon as possible in order to eliminate equipment and anthropogenic hazards. This is to ensure long term and stable equipment operation as well as delivery of latest technical information.
- Technical support: special paid services are provided according to customer’s needs.
- The damping spring of the machine should be regularly (about six months) inspected, make sure
no other debris in the spring.
- Users should regularly (about a year) check the machine screws, whether there is loosening
phenomenon.
- Users should regularly check (about a year) whether the power connector is loose.
Detailed Picture:
